9 Signs Your Water Heater Needs Repair
No hot water is obvious, but rumbling, rusty water and a dripping relief valve are quieter warnings. Here are nine signs and the safe checks you can do yourself.
Water heaters rarely fail without warning. Most give weeks or months of small signs first: a rumble when the burner lights, water that takes longer to warm up, a damp ring on the floor. Knowing the signs your water heater needs repair lets you replace a part instead of a tank, and lets you shut the unit off before a leak becomes a flooded closet or garage.
Below are nine signs, what each usually means, the checks you can safely do yourself, and when to turn the unit off and request a professional.
1. No hot water at all
On a gas heater this usually means the pilot or igniter is out, the thermocouple or flame sensor has failed, or the gas control valve has shut the unit down. On an electric heater it is usually a tripped breaker, a tripped high-limit switch or a failed heating element.
Safe check: look at the breaker panel. If the water heater breaker has tripped, reset it once. If it trips again, leave it off and request a professional. On a gas unit, see whether the status light on the gas control is blinking an error code and look the code up in the manual. Relighting a pilot by following the printed instructions on the tank is reasonable. If you smell gas, do not light anything; leave the area and call your gas utility.
2. Water that runs hot, then cold, then hot
Inconsistent temperature points to a failing thermostat, a bad lower element on an electric unit, a dip tube that has broken and is letting cold water mix at the top of the tank, or a tank so full of sediment that the usable hot volume has shrunk. On a tankless unit, temperature swings often mean scale on the heat exchanger or a flow-sensor problem.
3. Rumbling, popping or banging
This is the sound of water trapped under a layer of sediment boiling and bursting through it. The sediment is mostly dissolved minerals that drop out when water is heated, and North Texas water is a factor. The North Texas Municipal Water District, which supplies Frisco, Allen, McKinney, Little Elm and Garland, describes its treated water as “moderately hard,” and Garland’s 2025 water quality report lists total hardness up to 200 parts per million. Years of that leave a thick layer in the bottom of a tank.
Sediment makes the burner work harder, overheats the tank bottom and shortens the tank’s life. A plumber can flush it. On an older tank with heavy buildup, flushing sometimes reveals leaks that the sediment had been plugging, so ask about that risk before agreeing.
4. Rusty or discoloured hot water
Run cold water only at a tub. If it is clear, run hot. Rust or a brown tint only on the hot side means the inside of the tank or the anode rod is corroding. A worn anode rod can be replaced; a tank wall rusting from the inside cannot, and once it starts the tank is on its way out.
5. Water on the floor or in the pan
Where the water comes from matters.
- From the fittings on top: a loose or corroded inlet or outlet connection. Often a straightforward repair.
- From the drain valve at the bottom: the valve may be worn or not fully closed. Repairable.
- From the T&P discharge pipe: see sign 6.
- From the tank body or seams, or pooling under the tank with everything else dry: the tank itself has failed. That is a replacement, not a repair, and it will get worse.
If the pan under the heater has water in it and the pan’s drain line goes nowhere, be ready to shut the unit off at the first sign of steady flow.
6. The T&P valve is dripping or has discharged
The temperature and pressure relief valve on the side or top of the tank is a safety device. It opens if the tank gets too hot or the pressure climbs too high, and it discharges through a pipe that should end outside or at a drain. A valve that drips or has sprayed means one of three things: the valve itself is worn, the thermostat is overheating the water, or the house pressure is spiking because a thermal expansion tank is missing or has failed. Little Elm, for one, requires an expansion tank on town-supplied lines when a heater is replaced.
Safe check: feel the discharge pipe. If it is warm or wet, note it and request a professional. Do not cap or plug the discharge pipe, ever.
7. Pilot light problems or a yellow flame
A pilot that will not stay lit usually means a worn thermocouple or a dirty pilot assembly. A burner flame that is yellow and lazy rather than blue, or soot around the burner door, means incomplete combustion and needs a professional before further use. If a carbon monoxide alarm sounds, leave the house and call for help from outside.
8. The unit is old
Find the manufacture date on the rating label; it is often encoded in the serial number. The U.S. Department of Energy’s Energy Saver guide says most storage water heaters last 10 to 15 years, while tankless units can last more than 20. A 12-year-old tank with a new leak is usually not worth repairing; a 5-year-old tank with a failed element is. Age changes the question from “repair or not” to “repair or replace,” and the guide to when to replace a water heater covers that decision.
9. A rising gas or electric bill
If hot water use has not changed but the energy bill has climbed, the heater may be running longer to do the same work. Sediment, a failing element, a thermostat stuck high or a slow hot-water leak somewhere in the house are the usual causes. A hot-side slab leak keeps a heater cycling day and night; if the unit never seems to rest, run the meter test in how to tell if you have a slab leak.
Signs your water heater needs repair now: when to shut it off
Shut the unit down and request a professional if you see any of these:
- Water pooling from the tank body
- The T&P valve discharging steadily
- A gas smell, soot or a yellow flame
- A breaker that trips again after one reset
- Scalding water that you cannot turn down at the thermostat
To shut off a gas heater: turn the gas control knob to OFF, then close the cold water inlet valve on top of the tank.
To shut off an electric heater: switch off the breaker labelled for the water heater first, then close the cold inlet valve. Never open an access panel with the breaker on.
If the tank is leaking fast and the inlet valve will not close, shut off the main water supply to the house at the house valve or the meter.
Repair, replace and permits
Thermocouples, elements, thermostats, anode rods, dip tubes, drain valves and T&P valves are all replaceable parts. A rusting tank, a cracked heat exchanger or a tank at the end of its life are replacements. Expect the plumber to walk you through both paths with written estimates, and ask whether the diagnostic fee is credited if you proceed.
Most North Texas cities require a permit and inspection for a water heater replacement; Grapevine’s building FAQ says it is illegal for anyone, even a homeowner, to replace one without a permit. The plumber pulls the permit under their licence, and it should appear on the estimate.
Getting help
If you would rather not call around, call 866-896-2687 or send a request, and a local plumber will usually call back to confirm details and book a time. You review the written estimate before approving work.
Related reading
Sources
- U.S. Department of Energy, Energy Saver guide (water heater lifespans)
- North Texas Municipal Water District, Protecting Our Drinking Water (water hardness)
- City of Garland, 2025 Water Quality Report
- Town of Little Elm, Water Heater Replacement Regulations
- City of Grapevine, Building Services FAQ (water heater permits)
Need a hand with this?
A local plumber will usually call to confirm the details, whether you’re in Frisco, Garland, Little Elm or elsewhere in North Texas.
Quick answers
Is a rumbling water heater dangerous?
Rumbling itself is not dangerous; it is water boiling under a layer of sediment at the bottom of the tank. The problem is what the sediment does over time: it insulates the tank bottom from the water, so the burner overheats the steel and shortens the tank's life. In North Texas, where NTMWD describes its treated water as moderately hard, a flush every year or two keeps the layer thin. Ask the plumber about the risk of a flush uncovering small leaks on an older tank.
Why is the relief valve on my water heater dripping?
The temperature and pressure relief valve opens when the tank is too hot or the pressure is too high. A steady drip usually means one of three things: the valve itself is worn, the thermostat is overheating the water, or house pressure is spiking because a thermal expansion tank is missing or has failed. Never cap the discharge pipe. Note whether the pipe is warm or wet and request a professional.
Can I repair a leaking water heater tank?
If the water is coming from a fitting on top, the drain valve or the relief valve, those parts can be repaired or replaced. If the water is coming from the tank body or seams, or pooling under the tank with everything else dry, the inner tank has rusted through and cannot be repaired. That is a replacement, and it will not stop on its own.
Do I need a permit to replace a water heater in North Texas?
In most DFW cities, yes. Grapevine's building FAQ says it is illegal for anyone, even a homeowner, to replace a water heater without a permit, and Little Elm requires a permit and final inspection for every replacement. The plumber pulls the permit under their licence; ask to see it listed on the estimate.
More on water heaters
Tankless vs. Traditional Water Heaters: Which Is Right for a North Texas Home?
Tankless heaters last longer and never run out of hot water, but they cost more to install and need scale care. Here is how the two compare in North Texas homes.
Read the guide Water HeatersWhen to Replace a Water Heater: Age, Warning Signs and Repair-or-Replace Math
A tank past about 10 years, a leak at the base or rusty hot water usually means replacement. Here is how to read the age, weigh repair against replacement and prepare.
Read the guideNeed a plumber today?
Call or send a request. A local plumber will usually get back to you to confirm the details. Requests are accepted around the clock.