Requests accepted 24 hours a day, 7 days a week Call 866-896-2687
Plumbing service

Garbage Disposal Repair & Installation Help in Dallas–Fort Worth

Requests accepted 24/7Nine North Texas cities

A garbage disposal gives three kinds of trouble: it hums and does nothing, it leaks, or it’s simply dead. The first is usually a jam you can clear yourself with the power off. The second depends on where the water is coming from. The third is often a tripped reset button and only sometimes a dead motor. Garbage disposal repair is quick when the problem is a jam, a seal or a connection; a motor or a leaking housing means a new unit.

Tell us what the disposal is doing, roughly how old it is and where you are in North Texas, and we’ll help you find a plumber who repairs and installs disposals in your area. If one is available, they usually call you to confirm details and book a time.

What the symptom usually means

Symptom Likely cause Repair or replace
Hums but doesn’t spin Something jammed between the impeller plate and the grind ring Repair (clear the jam)
Nothing at all, no hum Tripped reset button or breaker, a dead wall switch, or a burned-out motor Repair unless the motor has failed
Trips the reset or breaker repeatedly Motor failing, or a jam that keeps recurring Usually replace
Leaks from the bottom of the unit Internal seal failed Replace
Leaks at the top, where it meets the sink Loose mounting ring or failed putty under the sink flange Repair (remount and reseal)
Leaks at the side Dishwasher inlet hose clamp, or the discharge tube gasket Repair

Humming but not spinning

The hum is the motor trying to turn against something it can’t move; left running, it overheats and trips its thermal cut-out. If you’re comfortable doing so:

  1. Turn off the switch and the breaker. Never put a hand in the chamber while the unit has power.
  2. Turn the motor by hand. Most disposals have a hex socket in the centre of the bottom; a quarter-inch Allen wrench rocks the impeller plate to free the jam. With no socket, a wooden spoon handle from above can lever the plate.
  3. Remove the object with tongs or pliers.
  4. Press the red reset button on the bottom, restore power, run cold water and test.

If it still hums once the plate turns freely, or trips the reset again at once, the motor is seizing.

Leaks: where the water comes from decides the fix

  • From the bottom of the housing, often through the reset button or a seam. The internal seal has failed and the motor will be next. Replace the unit.
  • From the top, at the sink flange. Dried-out putty under the flange or a loose mounting ring. The unit comes down, the flange is resealed and it goes back up.
  • From the dishwasher inlet on the side. A loose hose clamp or a split hose.
  • From the discharge tube where the drain connects. A gasket or a loose slip nut, the same logic as any sink drain leak.

Water under the sink that doesn’t track back to the disposal may be the trap, a supply line or the faucet, and ruling those out is part of the visit.

Repair or replace

Repair when the fault is a jam, a reset, a flange seal, a hose or a discharge gasket on a unit that otherwise works and isn’t rusting. Replace when the housing leaks, the motor hums or trips repeatedly, the grinding chamber is badly corroded, or the mounting hardware has seized with age. Most disposals last somewhere around a decade; light-duty units less, heavier ones more.

Choosing a replacement

  • Horsepower. 1/3 hp for very light use, 1/2 hp for a small household, 3/4 hp for a family that cooks daily, 1 hp for heavy use. More power means a bigger, heavier unit, so check cabinet space.
  • Continuous feed or batch feed. Continuous feed runs from a wall switch while you feed it and is what most homes have. Batch feed runs only when a stopper is turned in the opening, which is safer around small children and needs no switch.
  • Mounting. Staying within the same brand family usually means the existing sink mount can be reused. Switching brands means a new flange and mount.
  • Septic. A disposal adds solids to a septic tank. Septic-rated units help; many septic professionals still advise against one. Tell the plumber if the house is on septic.

What not to put down it

The disposal is for small scraps rinsed off plates, not a bin. The items behind most calls:

  • Grease, oil and fat, which solidify in the drain line, where most ‘disposal’ clogs actually sit.
  • Fibrous vegetables: celery, corn husks, onion skins, asparagus. The strands wrap around the impellers.
  • Starchy foods: potato peels, rice, pasta, oatmeal. They swell into a paste.
  • Coffee grounds, which settle in the trap like sediment.
  • Bones, fruit pits and shells, which rattle around until something breaks.
  • Anything that isn’t food: glass, twist ties, bottle caps, cutlery.

A disposal that backs up into the sink while the rest of the house drains normally is a drain cleaning job rather than a disposal fault. If other fixtures are affected at the same time, it’s a sewer line issue.

What happens after you call or send a request

  1. Tell us the problem and your address or ZIP. Call 866-896-2687 or use the request form. Mention the symptom, whether anything is leaking, and the brand and horsepower if you can read them off the unit.
  2. A local plumber usually calls you back. If a plumber who handles disposals is available in your area, they usually call to confirm the details and book a time.
  3. Review the written estimate. The plumber gives you an estimate in writing, and no work starts until you approve it.

Where we take garbage disposal repair requests

Disposal requests come from across Dallas–Fort Worth, including Aubrey, Little Elm, Denton, Mesquite and McKinney. Not on the list? See every North Texas area we cover.

Before the plumber arrives

  • Turn the disposal off at the switch and, if it’s leaking, at the breaker too.
  • Clear the cabinet under the sink and put a towel or shallow pan under the unit.
  • Note the brand and model from the label on the side or bottom.
  • Don’t run the dishwasher, which drains through the disposal.

If the disposal is being replaced as part of a larger kitchen job, see plumbing installation. More in our guides: Common causes of clogged drains and What to do before a plumber arrives.

Related reading

Garbage Disposal Repair & Installation: common questions

My disposal hums but will not spin. What should I do?

The hum is the motor straining against a jam. Turn off the wall switch and the breaker, then turn the motor by hand: most units have a hex socket in the centre of the bottom that takes a quarter-inch Allen wrench, and rocking it back and forth frees the impeller plate. Remove whatever was stuck with tongs, never fingers, press the red reset button on the bottom, restore power and test with cold water running. If it still hums with the plate turning freely, or trips the reset again immediately, the motor is failing and the unit needs replacing.

My disposal is leaking from the bottom. Can it be repaired?

No. Water coming out of the bottom of the housing, often through the reset button or a seam, means the internal seal between the grinding chamber and the motor has failed, and the motor will fail next. That seal is not a serviceable part. A leak at the top where the unit meets the sink, at the dishwasher hose or at the discharge pipe, on the other hand, is a seal, clamp or gasket and is repairable.

What horsepower garbage disposal do I need?

A 1/3 hp unit suits one person or very light use. A 1/2 hp unit is the common choice for a small household. A 3/4 hp unit handles a family that cooks daily and jams noticeably less. A 1 hp unit is for heavy use. More power means a larger, heavier unit, so check the cabinet space and whether the existing mount can be reused. If the old unit jammed often, going up one size is usually the right call.

Can I have a garbage disposal on a septic system?

You can, but it adds solids to the tank and shortens the time between pumpings. Septic-rated disposals inject an enzyme treatment to help break down food waste, which helps but does not eliminate the extra load. Many septic professionals advise against installing one at all. If you already have one, use it sparingly and tell the plumber the house is on septic so the recommendation reflects it.

What should never go down a garbage disposal?

Grease and oil, which solidify in the drain line beyond the disposal and cause most of the clogs blamed on it. Fibrous vegetables like celery, corn husks and onion skins, which wrap around the impellers. Starchy foods like potato peels, rice and pasta, which swell into a paste. Coffee grounds, bones, fruit pits and anything that is not food. Run cold water before, during and for several seconds after each use so what is ground actually leaves the line.

Do I need a plumber or an electrician to replace a disposal?

A like-for-like replacement into an existing outlet or hardwired connection is plumbing work, and the plumber handles the mounting, the drain connection and the dishwasher hose. If the kitchen has never had a disposal and needs a new switched outlet under the sink, that part is electrical work and is done by an electrician, usually before the plumber installs the unit.

Need garbage disposal repair & installation help today?

Call or send a request about garbage disposal repair & installation. A local plumber will usually get back to you to confirm the details. Requests are accepted around the clock.

Call 866-896-2687 Request Help