Requests accepted 24 hours a day, 7 days a week Call 866-896-2687
Maintenance

Plumbing Maintenance Tips for Texas Homeowners: A Season-by-Season Guide

North Texas plumbing fails on a schedule: sprinklers in spring, clay-soil leaks in summer, freezes in winter. Here is what to check each season and what to leave to a pro.

Most plumbing maintenance tips are generic. Texas homes have specific problems: clay soil that moves, freezes that arrive with little warning, moderately hard water, and sprinkler systems in nearly every yard. The calendar below ties each job to the season when it makes sense, so the list is short enough to actually finish.

Nothing here replaces a professional inspection, but all of it is something a homeowner can do or at least check. Where a task needs a licensed plumber, it says so.

Spring: after the winter, before the irrigation season

  • Test the sprinkler system. Run each zone and look for geysers, soggy spots and zones that do not turn on. A broken head wastes water and pools next to the foundation. The City of McKinney requires freeze sensors on all sprinkler systems, so confirm yours works.
  • Look at the backflow assembly. The device that keeps lawn water from flowing back into the house supply should not leak or look cracked after winter. Many cities require periodic testing of irrigation backflow assemblies, so check your city’s rule and use a tester who is qualified to do it.
  • Check the meter after a wet season. Turn off everything that uses water, then watch the meter dial or low-flow indicator. If it moves, water is going somewhere. That is the first test for a hidden leak, and leak detection is the next step.
  • Inspect under every sink and behind toilets for drips, rust on shut-off valves and swollen cabinet bottoms.

Summer: clay soil and slab leaks

Much of North Texas sits on Blackland clay. The Texas Water Development Board describes Houston Black clay, the state soil, as shrinking and swelling markedly with changes in moisture. In a dry summer the soil pulls away from the foundation, the slab shifts a little, and pipes under or near it flex.

  • Water the foundation evenly during long dry spells. A soaker hose, run on a timer a foot or two from the slab, keeps the soil from pulling away. Check for gaps between soil and slab.
  • Watch for slab-leak clues. A warm spot on the floor, the sound of running water when everything is off, an unexplained water bill, or damp carpet along an exterior wall. The guide to how to tell if you have a slab leak covers the signs in detail.
  • Hose bibs. Look at each outdoor faucet. A drip from the handle or the stem means worn packing, and water behind the wall is possible if the faucet leaks only when a hose is attached.
  • Do not stop running drains. Pour hot water down seldom-used floor drains and guest-bath sinks to keep the trap full, since a dry trap lets sewer gas into the house.

Fall: prepare for the first freeze

  • Disconnect hoses and cover or insulate outdoor faucets. A hose left on holds water against the spigot and can split it.
  • Insulate exposed pipes in the attic, garage and exterior walls with foam sleeves. Many North Texas homes have water lines in the attic that are barely wrapped.
  • Flush the water heater. Follow the manual: shut off the power or gas, close the cold supply, attach a hose to the drain valve and run until the water clears. Most manufacturers recommend doing this yearly. Tankless units have their own descaling procedure, and the City of Frisco’s cold weather page includes tankless-heater advice.
  • Test the main shut-off. Turn it off and on once now. If it is stiff, leaks or does not fully close, ask a plumber about replacing it before you need it. The main shut-off guide shows where the valve usually is.
  • Label the valve so anyone in the house can find it quickly.

Winter: the freeze protocol

Cities across the area publish nearly the same advice. Grapevine’s page says to drip faucets during extended freezes, open cabinet doors and insulate outdoor faucets. Denton’s Be Ready Denton page asks residents to drip faucets, open cabinets and cover spigots. McKinney’s weather page notes that a loss of water in cold weather is usually a frozen pipe on the owner’s side of the meter.

  1. Before the freeze: drip a faucet on each exterior wall, open cabinet doors under sinks, keep the thermostat at the same setting day and night, and cover outdoor faucets.
  2. During the freeze: check faucets in the morning. If one is down to a trickle, the line is freezing; keep the tap open and apply gentle heat. The burst pipe guide covers safe thawing.
  3. Know the main. If a pipe splits, shut off the main immediately and open faucets to drain the lines.
  4. After the thaw: check ceilings, walls and the meter. Many burst pipes start leaking only when the ice melts.

Yearly plumbing maintenance tips that need a professional

  • Pressure-reducing valve (PRV) check. Many homes have a PRV near the main that cuts street pressure down to a safe level. A plumber can test pressure and replace a valve that has drifted. High pressure wears out toilets, faucets and the water heater.
  • T&P valve test. The temperature and pressure relief valve on a tank water heater is a safety device. Testing it can cause it to leak afterward, so a professional should do it.
  • Sewer camera for older homes. Cast-iron and clay drains, or a house with roots in the yard, are good reasons for a camera inspection every few years. Drain cleaning and pipe repair are the services that follow if something shows up.

Getting help

If a job on this list is more than you want to take on, or you would rather not call around, call 866-896-2687 or send a request, and a local plumber will usually call back to confirm details and book a time. You review the written estimate before approving work. See the water heater repair page if the heater is the thing that has been nagging you.

Need a hand with this?

A local plumber will usually call to confirm the details, whether you’re in Frisco, Denton, Grapevine or elsewhere in North Texas.

Quick answers

How often should a Texas homeowner have plumbing inspected?

A walk-through of your own once a season catches most problems early, and a professional look once a year at the water heater, the shut-off valves and the water pressure is a reasonable routine. Homes more than about 30 years old, or homes that have had a leak, benefit from a sewer camera inspection every few years.

Should I flush my water heater every year?

Most manufacturers recommend flushing a tank heater annually to clear sediment, and North Texas water is moderately hard, so scale builds up. Follow the instructions in the heater's manual. If the drain valve is old and stuck or the heater has never been flushed, ask a plumber to do it, because a forced valve can start a leak.

How do I know whether my water pressure is too high?

A screw-on pressure gauge from a hardware store, attached to a hose bib, will tell you. Ongoing pressure above what a fixture's manufacturer recommends wears out fittings, toilets and the water heater. If your home has a pressure-reducing valve, a plumber can test it and replace it if the reading has drifted.

Do I need to do anything to my sprinkler system before winter?

Yes. Check that the freeze sensor works, drain or blow out exposed lines if your installer recommends it, and insulate the backflow assembly above ground. The City of McKinney says freeze sensors are required on all sprinkler systems there, and other cities have similar guidance on their cold-weather pages.

Need a plumber today?

Call or send a request. A local plumber will usually get back to you to confirm the details. Requests are accepted around the clock.

Call 866-896-2687 Request Help